Type Of Fitting; Important User Information; Preparing Food - hanseatic MC-IF6417B1-A Gebrauchsanleitung

Type of fitting

Important user information

The glass ceramic hob is intended to be fitted
in a kitchen worktop or the like. If you have
the requisite skills, you can fit the hob your-
self. However, the electrical connection must
be carried out by authorised specialist staff.
Requirements
To ensure proper operation, the following re-
quirements must be met:
– The appliance complies with heat protec-
tion class "Y" (EC 335-2-6), which means
that only one side of the appliance is al-
lowed to be next to taller kitchen units or
walls. The built-in furniture must have cov-
erings and the adhesives used must be
heat-resistant (100 °C). If this is not the
case, the covering surface may deform
or detach. If you do not know the thermal
resistance of your kitchen furniture, leave
a gap of approximately 2 cm between the
furniture and the stove.
– The distance between the appliance and
the extractor hood must be at least 760
mm.
– Always install exhaust hoods in accord-
ance with their user manuals.
– Do not place the cooker directly next to a
refrigerator or freezer. This will increase its
energy consumption unnecessarily due to
heat emission.
– You must leave at least 50 mm of free
space below the recess for ventilation pur-
poses. No heat-sensitive objects (cabinet,
drawers, etc.) should be located in this
area.
You may need to saw off or remove side
walls or drawers.
Type of fitting

Preparing food

To ensure proper operation, the following re-
quirements must be met:
– The worktop must be at least 30 mm thick
and at least 590 mm deep, must be hori-
zontal and level, and must be sealed on the
wall side against overflowing liquids.
– The appliance must be surrounded by at
least 50 mm of worktop on all sides.
min. 760 mm
min. 50 mm
min. 20 mm
If the appliance is separated from the rest of
the mounting cupboard using a horizontal fix-
ing plate, the space between the base of the
appliance and the fixing plate must be at least
50 mm high.
– If the appliance is separated from the rest
of the mounting cupboard using a vertical
fixing plate, the space between the wall
and the fixing plate must measure at least
20 mm.
– At the back of the fixing plate, a square
opening with a side diameter of at least
80 mm must be cut out.
Page EN-23
air outlet
min. 5 mm