Connecting And Removal Of Adaptor Nozzle; Inflating An Item; Regulating Pressure; Changing The Batteries - Parkside PDRD 13 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Note: Digital manometer has auto-off function,
whenever product stays alone without pressing
any functional button for about 30 seconds, it
will switch off automatically to save battery
energy.
Connecting and removal of
adaptor nozzle (see fig. D)
Press down lock lever
While pressing down lock lever
adaptor nozzle into the hole of connector
in direction a till it is completely reaching
10
the bottom of the hole.
Then release lock lever
To remove the adaptor nozzle by pres-
sing down lock lever
adaptor nozzle in direction b by comple-
tely away from the connector

Inflating an item

Check LCD display panel
set to zero before connecting to item to
be inflated.
Connect to the valve of the item to be
inflated securely.
Press down trigger
operations.
Monitor the pressure reading from LCD
display panel
2
Till reaching desired pressure, release
trigger to stop inflation.
8
Remove the adaptor nozzle from the
valve of the item to be inflated.

Regulating pressure

If there is too much air inflated into the
item or reaching pressure higher than
desired. Press down pressure release
button to release some of the air to
6
regulate the pressure.
10 GB
of connector
11 10
, insert
11
.
11
and pull out the
11
.
10
reading is
2
to process inflation
8
.
inflator from the compressed air source after
finishing the work to avoid expelling high
pressure air to people or animal by accident
that may cause personal injury.

Changing the batteries

(see fig. B)
. When battery level is low
replaced by new one. Always replace both
batteries.
Remove the battery compartment cover
on the rear side of digital manometer
Remove the exhausted batteries
battery compartment
Put the new batteries
partment . Check the polarity of the
17
battery is correctly connected.
Close the battery compartment
replacing the compartment cover

Maintenance

JURY! Always disconnect the product
from the compressed air supply before
cleaning it. The product does not require
special maintenance.

Cleaning

Do not use sharp objects to clean the
product.
Do not allow liquids to get inside the
product, this can cause damage to it.
Clean the product regularly. The best time
to do so is right after completing works.
Clean the product housing with a dry
cloth.
Always disconnect the
it needs to be
from
15
.
17
into battery com-
15
by
17
16
DANGER OF IN-
16
.
1
.