Cleaning & Maintenance; Error Handling - SPORTSTECH sBike Lite Benutzerhandbuch

The following colors are displayed depending on the pedaling power (watts) or pulse (if a pulse sensor
is connected) is displayed if you have not selected a permanent light color.
Blue Aqua
... for Pedaling Power:
0-100 W 101-150 W
... for PULSE (if a pulse sensor is connected):
< 110 110-126
BPM
6. Cleaning & Maintenance
WARNING! Risk of serious or fatal injuries due to electric shock!
Risk of injuries or material damage!
Never allow moisture to get on or into the power supply unit or the cable!
•
Never open or repair the power supply unit or cable!
• Never use the device if any components are loose or damaged.
If possible, tighten connections. If necessary, arrange for repair.
•
In all cases of doubt, contact customer service.
•
Cleaning
• After training, remove sweat from the device with a dry or slightly damp cloth. Do not use aggressive
detergents. Never allow moisture to penetrate a housing.
• Make sure that the nameplate and other stickers are intact and legible.
Maintenance
• Before and after each training session, check that the unit is in perfect condition. Also check that all
fastening parts and protective covers are in place and intact.
• Before each workout, check that the screws for all adjustable parts (front tube, seat tube, saddle) and
for all other connections are locked and tightened. Re-tighten, if necessary.
• The device is equipped with sealed bearings. Lubrication is not required.
Storage
• To move the device on the rollers, lift it only by the handle of the rear stand. When moving, make sure
that the monitor does not hit, swivel and/or collide.
• The storage location of the device must meet these requirements:
-Dry and clean interior, free of explosive or flammable substances and dust
- Temperature within the permissible range for operation (see technical data)
- No direct sunlight.
- For longer storage, protect against dust.

7. Error handling

Error
Device cannot be
switched on/ does not
start
No value display on
display knob
No pulse display
Device makes crunching
noise during exercise
In any case of doubt, contact our customer support. You find the contact data on the last page.
Green Yellow
151-200 W 201-250 W
127-144 145-161
BPM BPM
possible reason
Power cable not plugged in
Control error
SPORTSTECH LIVE APP not connected
No compatible heart rate sensor
Pulse sensor does not measure signal
Loosened connections
Orange Red
251-300 W 301-350 W
162-179 180-196
BPM BPM
possible solution
Plug in power cable
Reset: - Pull out the plug and plug it in again
after 5 minutes.
- Download and activate the app on your
mobile device.
- Position mobile device close to Speedbike.
Bluetooth-Pulssensor anlegen
Pulssensor korrekt am Körper anlegen
- Tighten adjustable parts.
- Tighten other connections.
EN DE
Purple
> 350 W
≥ 197
BPM BPM
39