2.5.3 Dumbbell holders
•
Hold the dumbbell holder to the intended position.
•
Fasten it with the two screws ('33') using a phillips screwdriver ('115').
2.6 MULTI-POSITION HANDLE WITH DISPLAY KNOB
•
Place the multi-position handle ('4') from above on the intended receptacle on the front tube ('12').
•
Push the screw with knob ('11'), and washer ('10') through the receptacle from below into the threaded
hole of the multiposition handle.
•
Hand-tighten the screw with knob ('11').
•
Plug the connectors '14A' and '14B' together.
14B
12
10
14A
11
2.7 FINAL STEPS
•
Check again the strength of all connections. Repeat these checks before each use.
•
Clean the device thoroughly before first use, as there may be oil residues and dust on it due to
production and packaging
4
#10 1X
#95 4X
M8x20L
#115 1X
EN
DE
31