2.3 INSERTING FRONT TUBE & HOLDER FOR MOBILE DEVICE
•
On the lower part of the front tube ('12'), loosen the rubber band on the connector ('14').
•
First person: Hold the front tube ('12') over its position on the main housing, as shown in the figure.
•
Second person: On the main frame, loosen the rubber band on the connector ('37').
•
Insert the plug '37' into the connector '14'. Prevent pinching of fingers.
•
Pull the knob ('Kn1') outwards against the spring force. If necessary, loosen it beforehand by turning it
a little to the left.
•
Carefully lower the front tube ('12') into the main housing ('43'). Do not clamp the cable. Observe the
required minimum depth.
•
Let go of the knob. Make sure that the locking pin on the knob snaps into one of the holes of the front
tube inside the main housing.
•
Tighten the knob with your hand.
•
Plug the mobile device holder ('1') into the receptacle at the top of the front tube ('12').
28
1
12
14
37
Kn1
43