Installation Instructions; Mounting The Feet - SPORTSTECH sBike Lite Benutzerhandbuch

2. Installation Instructions

• Tighten all individual parts and pre-assembled parts firmly!
Check the tightness again before each training session!
•
Perform the assembly with a second, adult and sufficiently strong person.
•
2.1 UNPACKING AND PREPARING
• Keep children and pets away from small parts and plastic bags.
• Use a suitable base to protect the device and the floor.
• Keep all parts of the packaging for a possible return for 30 days.

2.2 MOUNTING THE FEET

71
72
73
74
• First person: Lift the main housing ('43'). Embrace the saddle holder with both hands. Do not lift the
housing on the knob.
• Second person: Slide the rear stand ('110') under its receptacle.
• Carefully lower the main casing. Prevent pinching of fingers.
• Slide a screw ('71'), a spring washer ('72') and a washer ('73') through each hole of the receptacle into
the corresponding threaded hole of the stand.
• Tighten the screws by hand, using an Allen key ('115').
• Repeat the steps for the front stand ('74').
• Lift the housing with both hands on the receptacle for the front bar. Do not lift it by the knob.
EN DE
#73 4X
#72 4X
#71 4X
M8x50L
#115 1X
43
110
27