Aligning The Running Belt; Cleaning And Inspecting The Running Belt - SPORTSTECH DFT500 Benutzerhandbuch

ALIGNING THE RUNNING BELT

Ensure the running belt is centered on your treadmill at all times. Running style and non-level surface
are two instances which may cause the belt to drift off center.
Minor adjustments to the two bolts at the rear of the treadmill are necessary when the belt has drifted
off center (See Fig. A & B).
1. Press the Master Power Switch (located at the front of the treadmill) to ON position and ensure
Safety Key is properly placed onto the computer console, press the START button to begin running,
then increase the treadmill's speed to 3 kph.
2. Stand right behind the treadmill and to determine which side the belt is drifting.
3. If the belt drifts to the right, turn the right adjustment bolt. one-quarter of a turn clockwise and the
left adjustment bolt. one-quarter counter clockwise (See Fig. A).
4. If the belt drifts to the left, turn the left adjustment bolt. one-quarter of a turn clockwise and turn
the right adjustment bolt. one-quarter turn counter-clockwise (See Fig. B).
5. Observe the tracking of the belt for about two minutes. Repeat Steps 3, 4, and 5 as needed.
FIGURE A
FIGURE B

CLEANING AND INSPECTING THE RUNNING BELT

Turn off power and unplug from electrical outlet.
Carefully position the treadmill on its side.
Use a damp cloth to wipe off the inside of the running belt. Carefully rotate the running belt by hand
to clean the entire inside face. Return treadmill to its upright Position.
If running belt edges are frayed, check the running belt adjustment.
If seams are splitting, call your retailer or nearest authorized service center.
71