Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.1.4 Arrow Keys
5.2 Display
5.2.1 Speed | RCF (Relative
Centrifugal Force)
5.2.2 Speed | Relative
Centrifugal Force | Time
20
Operating Elements
These keys can be used in the
1. run mode
– to change between speed and RCF display,
2. edit mode
– to alter the parameters.
The display consists of three segments:
In the upper line speed and gravitational field are displayed, the lower line shows the
run time, the middle line indicates "soft stop" and "short run".
Rotor dimensions and speed determine the RCF value. Entering either the speed or
the RCF automatically determines the other one. In the run mode, pressing the arrow
keys changes between speed and RCF display.
In the upper line the set speed or the relative centrifugal acceleration is displayed.
– The speed is displayed in rotations per minute (rpm).
– The relative centrifugal force | RCF is the acceleration which the sample is exposed
to (+ g).
– The time is displayed in minutes | seconds (m, s).
– Activate the edit mode using the "Select" key. One segment of the display is flashing.
– Select the desired parameter using the "Select" key and change the value using the
arrow keys.
– The values are entered immediately and are saved automatically after 20 seconds.
– Close the centrifuge lid and start the run by pressing the "Start | Stop" key.
During operation, you can switch from the speed value to the RCF value and
vice versa via the arrow keys.
Werbung
Inhaltsverzeichnis
