Initial Start-Up; Switching On The Centrifuge; Opening Lid; Installation Of A Rotor - Sartorius Stedim Biotech CENTRISART A-14 Betriebsanleitung

4.4 Initial Start-Up

4.4.1 Switching on the
Centrifuge

4.4.2 Opening Lid

4.4.3 Installation of a Rotor

18 Installation and Start-up
Attention:
Before initial start-up please make sure that your centrifuge has been properly
installed (see 4.2 Installation).
– Press mains switch (rear panel).
– The centrifuge display is illuminated.
– The lid opens automatically.
– Press the Lid-key.
– The lid opens automatically.
Put a rotor onto the shaft and fasten it by screwing the rotor fastening nut clockwise
onto the drive shaft: During this process, hold rotor with one hand on its outer rim
(see 4.3 Installation of Rotors and Accessories).