5. Operating Elements
5.1 Operating Panel
5.1.1 Start | Stop Key
5.1.2 Select Key
5.1.3 Lid Key
5. Operating Elements
The centrifuge is operated via the operating panel.
When power is applied, the centrifuge enters the display mode after a short system
check.
With this key you can:
– Start the centrifuge,
– terminate a previously started deceleration process and restarting the centrifuge,
– shift to short run (see 5.2.8 Short Run),
– early termination of the centrifuge run.
The centrifuge can be started when
– the lid is closed.
This key can be used to
– activate the edit mode,
– select the parameter to be changed.
This key can be used to
– open the lid.
The lid can only be opened, if
– the centrifuge has not been started yet.
Operating Elements
19