Crosstalk; General Information - HBK MCS10 Montageanleitung

7

CROSSTALK

7.1

General information

The crosstalk is possible when a transducer outputs more than one component or where
more than one component is recorded. The maximum is a six-component transducer
describing all the degrees of freedom: the three forces Fx, Fy, Fz, and the moments Mx,
My and Mz.
If a single load is applied, e.g. the axial force Fz, the other measuring bridges will output a
very small signal. This unwanted signal is called crosstalk.
MCS10
CROSSTALK
19