Auto Power-Off Function; Torch - VOLTCRAFT VC232 Bedienungsanleitung

13.4 Auto power-off function

The multimeter switches off automatically after 15 minutes if no buttons are
pressed. This function saves battery power and prolongs the battery life. The
symbol will be displayed when the automatic power-off feature is enabled.
The multimeter will beep several times approximately 1 minute before it turns
off. If the SEL/
multimeter will beep again in 15 minutes. A long beep indicates that the multi-
meter is switching off.
To switch the DMM back on, move the control dial over the "OFF" position or
press the SEL/
The automatic power-off feature can be disabled.
Follow the steps below to disable the automatic power-off feature:
1. Switch the multimeter off (move the control dial to the "OFF" position).
2. Hold down the SEL/
The multimeter will switch on and the
Æ
on the display.
The automatic power-off feature will remain disabled until the multimeter is
Æ
turned off using the control dial.

13.5 Torch

Long press the SEL/
button is pressed before the multimeter switches off, the
button.
button and switch on the DMM using the control dial.
button to switch the torch ON/OFF.
symbol will no longer be visible
73