VOLTCRAFT VC232 Bedienungsanleitung Seite 50

ceramic tube fuse will work and probably blow to protect the meter. In such case, the
blown ceramic tube fuse is required to be replaced by a new one.
The device switches off automatically after 15 minutes if no buttons are pressed to
prevent the battery from draining. The automatic power-off function can be disabled.
A fold-out stand is attached to the back of the multimeter. This allows you to place
the multimeter on a level surface for better readability.
Do not use the multimeter when the battery compartment is open or when the bat-
tery compartment cover is missing.
Do not take measurements in potentially explosive areas, damp rooms or adverse
conditions. Adverse conditions include: Moisture or high humidity, dust and flamma-
ble gases, vapours or solvents, thunderstorms, and strong electromagnetic fields.
For safety reasons, only use test leads or accessories that match the multimeter's
specifications and meet IEC/EN 61010-031 standards.
The multimeter must only be used by people who are familiar with the relevant
regulations and understand the potential hazards. The use of personal protective
equipment is recommended.
Using this product for any purposes other than those described above may damage
the product and result in a short circuit, fire or electric shock. The product must not
be modified or reassembled!
Read the operating instructions carefully and keep them in a safe place for future
reference.
Always observe the safety information in these instructions.
50