VOLTCRAFT VC232 Bedienungsanleitung Seite 65

12.5.1 Follow the steps below to measure AC
1. Set the function dial to µA , mA , or A.
The corresponding unit of measurement will appear on the display.
Æ
2. Short press the SEL/
3. Select the desired measurement range and connect the corresponding termi-
nals.
Measurement mode
µA
mA
A
4. Insert the red lead into the mAµA or 10A terminal.
5. Plug the black test lead into the COM terminal.
6. Connect the two measuring probes in series to the object that you want to meas-
ure (e.g. battery or circuit). The electrical circuit must be disconnected before
you connect the probes.
7. Reconnect the circuit. The measurement will appear on the display.
8. After measuring, disconnect the circuit and remove the test leads from the
measured object. Switch off the DMM.
button to select "AC".
Measurement range
<2000 µA
2000 µA - 200 mA
200 mA – 10 A
currents (A)
Terminals
COM + mAµA
COM + mAµA
COM + 10A
65