Loz Voltage Mode - VOLTCRAFT VC232 Bedienungsanleitung

12.4 LoZ voltage mode

LoZ mode allows you to measure DC and AC voltages with a low impedance (ap-
prox. 400 kΩ). In this mode, the multimeter lowers the internal resistance to prevent
'phantom' voltage readings. As a result, the circuit is more heavily loaded than in the
standard measuring mode.
1. To enable LoZ mode, press the LoZ button when taking a voltage measurement.
The impedance will be reduced until you release the button.
2. "LoZ" will appear on the display.
LoZ mode can only be used for circuits with a voltage of up to 250 V for a
maximum of 3 seconds. This function is not available in mV mode.
After using LoZ mode, leave the multimeter for 1 minute before using it
again.
63