InPro 8000 Series
5.
Removal from operation, storage, disposal
5.1
Removal from operation
The sensor is only conditionally subject to aging. When employed correctly
as intended and appropriately maintained and serviced, the lifetime of the
sensor can extend to several years.
Before removing the sensor from the process/process adapter, it must be
ensured that the process pressure has been reduced to a safe level and
the process temperature lowered to a safe range. Any escape of hot pro-
cess medium under pressure can cause damage to material/equipment or
injury to persons.
After demounting, the sensor should first be flushed with clear water.
If the sensor incurs a defect, it can as a rule not be repaired and must
be disposed under observance of prevailing regulations.
5.2
Storage
If the sensor is not needed for use, it can be stored dry.
5.3
Environmental protection
Waste electrical products should not be disposed of with house-
hold waste. Please recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
© 09/2022 METTLER TOLEDO
Printed in Switzerland
16
InPro 8000 Series
52 800 247