Testing The Sensor / Sensor Head; With The Transmitter; Intelligent Sensor Management: Ism; Storage, Warranty And Disposal - Mettler Toledo InSUS H60i Bedienungsanleitung

14
6�1�2 Testing the
If the measured values differ from the expected value, an air
calibration should be performed.
Appropriate values for Phi0 and Phi100 are:
InSUS O
Phi0
≥48°
The phase values of the sensor are stored in the calibration
history. The actual phase value can be checked in the "Cal-
ibration – Verify" menu.
If after such procedures the above mentioned values are
still not reached, the
Zero oxygen measurement can be done by using CO
nitrogen (N
ed with one of these gases.
After 2 minutes in an oxygen-free sample medium, the
reading on the transmitter should drop to below 5 % of the
reading in ambient air, and within 10 minutes the value
should have dropped to below 1 %.
If after such procedures the above mentioned values are
still not reached, the
For a detailed inspection of the InSUS H60i please contact
your local METTLER TOLEDO representative.
6�1�3 Intelligent Sensor Management: ISM
h
Note: Each time the sensor head is connected with a new
single-use oxygen sensor and diagnostic functions are
activated, DLI / ACT settings must be reset on the transmit-
ter. Please refer to the manual of the transmitter.
Dynamic Lifetime Indicator: DLI
The DLI provides information about the remaining lifetime
of an optical InSUS O
zero days, the system is within the specified accuracy after
a calibration. If the DLI is zero, the InSUS O
not be used.
Contributing factors for aging of the optical InSUS O
• number of measurements
• temperature during measurement
• oxygen concentration during measurement
Adaptive Calibration Timer: ACT
The ACT provides information as to when the next calibra-
tion is required to ensure measurements will remain within
the specified accuracy. This calculation is based on the DLI
information.
7

Storage, Warranty and Disposal

For storage, the sensor head should be clean and
dry. The protection caps have to be placed on the
sensor head
of manufacturing faults, 12 months warranty from
date of production is granted.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your Local Authority for disposal or
recycling advice.
InSUS H60i
30 802 188 A
Sensor / Sensor Head
sensors
2
single-use sensor
), or alternatively
2
single-use sensor
and the cable connectors.
Phi100
≥20°
in a sample medium saturat-
sensor. As long as the DLI is above
2
© 09 / 2022 METTLER TOLEDO
InSUS H60i

with the Transmitter

should not be used.
should not be used.
sensor should
2
In the event
Printed in Switzerland
or
2
sensor:
2