Mettler Toledo InPro 8000-Serie Bedienungsanleitung Seite 13

InPro 8000 Series
Connecting InPro 8000 Series Sensor to
M800 Process 1-Channel Transmitter
Fig. 1: Special slotted gaskets for cable
gland fitting with fiber optic.
Two special slotted gaskets for cable glands (M25 x 1.5) are included in
M800 Process 1-Channel transmitter delivery (Fig 1). Correct installation of
these two gaskets is important to ensure proper transmitter ingress protection
and to ensure the fiber optic cables are fixed properly to the transmitter.
The gaskets are pre-installed to the fiber optic cables, as Fig 2.
Note: Any vibration/movement of the fiber optic cables will affect the stability
of the measurement.
Fig. 3: Gaskets are fit through M25 x 1.5
cable glands.
The gaskets are fit through M25 x 1.5 cable glands. (Fig.3).
Fiber optic cables are connected to "Receiver" and "Emitter" on M800 trans-
mitters (Fig 4). Tighten the cable glands' screws by hand.
Note: Blue and orange fiber optic cables are identical. Which means
commissioning engineer can connects the two fiber optic cables without
considering the fiber optic cable color.
© 09/2022 METTLER TOLEDO
Printed in Switzerland
Fig. 2: Gaskets mounted on fiber
optic cable.
Fig. 4: SMA-connection to M800
transmitter "Receiver/Emitter".
InPro 8000 Series
13
52 800 247