Safety Instructions; Examples Of Some Typical Applications - Mettler Toledo InSUS H60i Bedienungsanleitung

6
• Correct equipment operation in conformance with the
prescribed environmental and operational conditions,
and admissible installation positions.
• Consultation with
in the event of any uncertainties.
2�3

Safety Instructions

• The plant operator must be fully aware of the potential
risks and hazards attached to operation of the particular
process or plant. The operator is responsible for correct
training of the workforce, for signs and markings indicat-
ing sources of possible danger, and for the selection of
appropriate, state-of-the-art instrumentation.
• It is essential that personnel involved in the commission-
ing, operation or maintenance of these sensors or of any
of the associated equipment (e.g. single-use bags, trans-
mitters, etc.) be properly trained in the process itself, as
well as in the use and handling of the associated equip-
ment. This includes having read and understood this
instruction manual.
• The safety of personnel as well as of the plant itself is
ultimately the responsibility of the plant operator. This
applies in particular in the case of plants operating in
hazardous zones.
• The oxygen sensors and associated components have
no effect on the process itself and cannot influence it in
the sense of any form of control system.
• Maintenance and service intervals and schedules depend
on the application conditions, composition of the sample
media, plant equipment and significance of the safety con-
trol features of the measuring system. Processes vary con-
siderably, so that schedules, where such are specified, can
only be regarded as tentative and must in any case be in-
dividually established and verified by the plant operator.
• Where specific safeguards such as locks, labels, or re-
dundant measuring systems are necessary, these must
be provided by the plant operator.
• A defective sensor head must neither be installed nor put
into service.
• Only maintenance work described in this operating in-
struction may be performed on the sensors.
• When changing faulty components, use only original
spare parts obtainable from your METTLER TOLEDO sup-
plier
• No modifications to the sensors and the accessories are
allowed. The manufacturer accepts no responsibility for
damages caused by unauthorized modifications. The
risk is borne entirely by the user.
2�4

Examples of Some Typical Applications

Below is a list of examples of typical fields of application
for the oxygen sensors. This list is not exhaustive.
Measurement in liquids:
• Fermentation
• Bio-Tech
InSUS H60i
30 802 188 A
(see chapter 9).
METTLER TOLEDO
© 09 / 2022 METTLER TOLEDO
InSUS H60i
Process Analytics
Printed in Switzerland