Introduction; Safety Instructions; Product Description - Mettler Toledo InPro 8600 i Serie Kurzanleitung

en
18
1

Introduction

Thank you for buying this InPro
METTLER TOLEDO. The InPro 8600i Series of sensors are
used for the determination of undissolved particles or sub-
stances in solutions. They are designed for measuring low
to medium levels of turbidity and coloration.
2

Safety instructions

h
Notice: Before every start-up, the sensor must be checked
for:
– Damage to the connections, fastenings, etc.
– Leakage
– Perfect functioning
– A uthorization for use in conjunction with other plant equip-
ment and resources.
h
Notice: The manufacturer / supplier accepts no responsibil-
ity for any damage caused by unauthorized attachments
or for the incorporation of spare parts which are not of
METTLER TOLEDO provenance. The risk is borne entirely by
the operator.
a
Caution: Before the sensor is put into operation, the operator
must have already clarified that use of the sensor in conjunc-
tion with the other associated equipment and resources is
fully authorized.
a
Caution: A defective sensor may neither be installed nor
put into operation. Faulty containment or installation out of
conformance with regulations and instructions can lead to
the escape of medium or to pressure surges (explosion),
potentially harmful both to persons and to the environment.
a
Caution: The sensor is not equipped with heat protection.
During steam-sterilization procedures in pipes, the surface
of the sensor can reach high temperatures and cause burns.
a
Caution: Some components inside the sensor are energized
with voltages which can cause lethal shocks in case of con-
tact. The instrument needs to be switched to zero potential
before any operation on the wiring terminal.
a
Warning: Before dismantling the sensor or commencing
any maintenance work on it, ensure that the equipment in
which the sensor is installed is in a safe condition (pressur-
ize, no explosion risk, empty, rinse, vent, etc.).
3

Product description

The label on the housing contains the following information:
InPro 8600 i / xy
x: D = digital connection of the sensor with a transmitter
M800 1-channel
y: 1 = single-angle version (25 °)
3 = dual-angle plus colour version (25 ° and 90 ° plus
colour)
Serial number
The serial number can be found on the label on the sensor.
Sensor certifications
The label located on the sensor provides the information
about the sensor certifications.
InPro 8600 i Sensors
30 313 251 B
InPro 8600 i Sensors
8600i Series sensor from
®
© 06 / 2019 Mettler-Toledo GmbH
Printed in Switzerland