Introduction; Safety Instructions - Mettler Toledo InPro 6000 Betriebsanleitung

InPro 6000 Optical O
1

Introduction

Thank you for buying this optical oxygen sensor
from METTLER TOLEDO. The InPro 6000 optical O
sensors are intended solely for in-line measurement
of the oxygen partial pressure. The optical oxygen
sensors with integrated temperature probes are used
for measurement of oxygen in hygienic applications
such as bio-tech fermentation and food & beverage
applications.
The sensors are sterilizable and compatible with CIP
(cleaning-in-place). For fermentation applications the
InPro 6860 i is applicable and fully sterilizable / auto-
clavable. The InPro 6960 i and 6970 i are intended
for use in the food & beverage industry for measuring
high and low ppb levels of oxygen respectively.
2

Safety instructions

h Notice: Before every start-up, the sensor must be
checked for:
– Damage to the connections, fastenings, etc.
– Leakage
– Perfect functioning
– A uthorization for use in conjunction with other plant
equipment and resources.
Notice: The manufacturer / supplier accepts no re-
h
sponsibility for any damage caused by unauthorized
attachments or for the incorporation of spare parts
which are not of METTLER TOLEDO provenance. The
risk is borne entirely by the operator.
a
Caution: Before the sensor is put into operation, the
operator must have already clarified that use of the
sensor in conjunction with the other associated equip-
ment and resources is fully authorized.
a
Caution: A defective sensor may neither be installed
nor put into operation. Faulty containment or instal-
lation out of conformance with regulations and in-
structions can lead to the escape of medium or to
pressure surges (explosion), potentially harmful both
to persons and to the environment.
a
Caution: The sensor is not equipped with heat protec-
tion. During steam-sterilization procedures in pipes,
the surface of the sensor can reach high temperatures
and cause burns.
a
Caution: Some components inside the sensor are en-
ergized with voltages which can cause lethal shocks in
case of contact. The instrument needs to be switched
to zero potential before any operation on the wiring
terminal.
© 03 / 16 Mettler-Toledo GmbH
Printed in Switzerland
Sensors
2
InPro 6000 Optical O
en
21
2
Sensors
2
30 313 394