Scope Of Delivery; Installation; Connection; Insus H60I - Mettler Toledo InSUS H60i Bedienungsanleitung

8
3�3

Scope of Delivery

Each sensor head
tested for
• a protective cap and a cap clip
• this manual and a Quick Setup Guide
• a Quality Control Certificate
• a Declaration of Conformity
• a 3.1 material certificate
InSUS H60i with
protective cap.
1: VP8 connector

2: InSUS H60i

3: Clip
4: Sensor connector
5: Protective cap
6: InSUS O
4

Installation

4�1

Connection

4�1�1 Connection of the Single-Use Sensor to the
Remove the rubber cap from the InSUS O
screw the protective cap from the InSUS H60i. Mount the
protective cap on the clip holder. Screw the InSUS H60i
sensor connector to the InSUS O
h Note: For protection of the optical tip of the InSUS H60i from
damage and dirt, reattach the protective cap to the sensor
head whenever the InSUS H60i is not connected to an InSUS
O sensor.
2
4�1�2 Digital Connection of the
Transmitter M400 or M800
The sensor head is connected to the transmitter via a
cable.
different lengths.
between the transmitter and the sensor head under harsh
industrial conditions. To connect
head, align the slit of the connector with the pin in the plug,
then tightly screw the plug to fasten the two parts.
InSUS H60i
30 802 188 A
is supplied fully assembled and factory
correct function together with:
1
2
3
4
5
sensor – not supplied with InSUS H60i
2
The cables are available from METTLER TOLEDO in
The cable
InSUS H60i connected with
an InSUS O
sensor, protective cap on
clip holder.
sensor.
2
InSUS H60i
ensures a secure connection
the cable
© 09 / 2022 METTLER TOLEDO
Printed in Switzerland
InSUS H60i
6
single-use
2
InSUS H60i
sensor and un-
2

to a Transmitter

to the sensor
VP8