Safety Instructions - Mettler Toledo InPro 6950 Serie Bedienungsanleitung

InPro 6950 Series O
– c orrect equipment operation in conformance with
the prescribed environmental and operational con-
ditions, and admissible installation positions.
– c onsultation with METTLER TOLEDO Process Ana-
lytics in the event of any uncertainties.
2.3

Safety instructions

– T he plant operator must be fully aware of the
potential risks and hazards attached to operation
of the particular process or plant. The operator is
responsible for correct training of the workforce, for
signs and markings indicating sources of possible
danger, and for the selection of appropriate, state-
of-the-art instrumentation.
– I t is essential that personnel involved in the
commissioning, operation or maintenance of these
sensors or of any of the associated equipment
(e.g. housings, transmitters, etc.) be properly
trained in the process itself, as well as in the use
and handling of the associated equipment. This
includes having read and understood this
instruction manual.
– T he safety of personnel as well as of the plant
itself is ultimately the responsibility of the plant
operator. This applies in particular in the case of
plants operating in hazardous zones.
– T he oxygen sensors and associated components
have no effect on the process itself and cannot
i nfluence it in the sense of any form of control
system.
– M aintenance and service intervals and schedules
depend on the application conditions, composi-
tion of the sample media, plant equipment and
signi fi cance of the safety control features of the
measuring system. Processes vary considerably,
so that schedules, where such are specified, can
only be regarded as tentative and must in any
case be individually established and verified by
the plant operator.
– W here specific safeguards such as locks, labels,
or redundant measuring systems are necessary,
these must be provided by the plant operator.
– A defective sensor must neither be installed nor
put into service.
– O nly maintenance work described in this operating
instruction may be performed on the sensors.
– W hen changing faulty components, use only
original spare parts obtainable from your
METTLER TOLEDO supplier (see spare parts list,
"Section 9.3").
© 02 / 2023 METTLER TOLEDO
Printed in Switzerland
Sensor 12 mm
2
7
InPro 6950
52 206 137 F