Parkside PHSA 20-Li B2 Bedienungs- Und Sicherheitshinweise Seite 16

9) Hold the hedge trimmer correctly,
e.g. with both hands on the
handles, if there are two handles.
Loss of control of the equipment may result
in injuries .
˜ Further safety directions
1) The appliance is designed for
trimming hedges. Do not use to
cut twigs, hard wood or other
objects. This could damage the
appliance .
2) Do not attempt to release a
blocked/jammed blade safety bar
before turning off the power and
removing the battery. There is a risk
of injury .
3) When operating the appliance,
always hold it well with both
hands and at some distance away
from your body. This enables better
control of the power tool in unexpected
situations .
4) Do not use the tool in the
vicinity of flammable liquids or
gasses. Fire- and explosion risk exist in
the event of a short circuit .
5) The blades have to be checked for
wear in regular intervals and re‑
sharpened. Blunt blades will overload
the machine . Resulting damages are not
covered by warranty .
14 GB/CY
6) Do not attempt to repair the tool
yourself, unless you are schooled
in this field. All works, which are
not described in this manual, may
only be performed by our Service‑
Centre. Many accidents are caused by
poorly maintained equipment .
7) Do not use any accessories
that are not recommended by
PARKSIDE. This can result in electric
shock or fire .
8) Work standing on the ground and
keep your balance. Do not work while
standing on unstable support .
˜ Vibration and noise
reduction
To reduce the impact of noise and vibration
emission, limit the time of operation, use low-
vibration and low-noise operating modes as
well as wear personal protective equipment .
Take the following points into account to
minimise the vibration and noise exposure risks:
Only use the product as intended by its
design and these instructions .
Ensure that the product is in good condition
and well maintained .
Use correct accessory tools for the product
and ensure they are in good condition .
Keep tight grip on the handles/grip surface .
Maintain this product in accordance with
these instructions and keep it well lubricated
(where appropriate) .