Maintenance
Before any maintenance:
–
Switch the product off .
Remove the battery pack
–
Let the product cool down .
–
Before every use: Check the product for
defects such as loose, worn or damaged
parts .
Apply oil to the safety knife bar
can or spray (Fig . I and Fig . K) .
Check that the screws in the safety knife
2 ]
[
bar
are tight .
Check covers and safety devices for
damages and correct installation . Replace
as necessary .
Troubleshooting
Problem
Product does not
start .
Intermittent operation
2 ]
[
Safety knife bar
gets too hot .
The product cuts
poorly .
[
15 ]
.
2 ]
[
by oil
Possible cause
15 ]
[
Battery pack
is empty .
[
15 ]
Battery pack
is not properly
inserted .
4 ]
[
Safety switch
not pressed
properly .
Internal wiring is defective .
The on/off switch
defective .
Too much friction due to lack of
lubrication .
Too much friction due to lack of
lubrication .
The safety knife bar
Suboptimal cutting technique .
Use a knife grinder to sharpen and smooth
out minor nudges on the cutting edge of the
safety knife bar
Contact a specialist to have a blunt, bent or
damaged safety knife bar
m
WARNING! RISK OF INJURY!
u
Do not try to install a safety knife bar
yourself . Installing a knife safety bar shall
only be done by a specialist .
Any maintenance and repair other than
described in this manual: Contact an
authorised service centre or a similarly
qualified person to check or repair the
product . Only use original parts .
Action
Charge battery pack
(see "Charging the battery
pack") .
Insert battery pack
(see "Removing/inserting the
battery pack") .
Switch the product on correctly
(see "Switching the product on/
off") .
Send the product to Service
7 ]
[
is
Centre for repair .
Oil the safety knife bar
Oil the safety knife bar
[
2 ]
is dirty .
Clean the safety knife bar
Adjust cutting technique
(see "Working instructions") .
2 ]
[
.
2 ]
[
replaced .
15 ]
[
[
15 ]
correctly
2 ]
[
.
2 ]
[
.
2 ]
[
GB/CY
2 ]
[
.
21