Operation; Switching On And Off; Trial Run; Grinding - Parkside PWSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Operation

Q
CAUTION! RISK OF INJURY!
Keep your hands away from the accessory
u
when the product is in operation.

Switching on and off

Q
This power tool is to be switched on in two steps.
Switching on:
1. Push the rear part of the on / off
switch down and slide it forward.
12
For continuous activation, now tilt the front
part downwards until it engages.
Switching off:
1. Press the rear part of the on / off switch
so that it snaps back into its off-position to
switch the product off.

Trial run

Q
NOTE
Always carry out a trial run before carrying
u
out your first grinding procedure and after
every accessory replacement. Switch the
product off immediately if the accessory is not
rotating smoothly, if considerable vibration
occurs or if you hear abnormal noises.

Grinding

Q
WARNING!
Never use a cutting disc for grinding!
u
1. Hold the product at a 10° to 15° angle for
easy handling and smooth grinding results.
2. Apply the grinding disc to the work surface
with a light, steady pressure for maximum
grinding efficiency. It should never be
necessary to force the product. The weight of
the product applies adequate pressure.
3. Excessive pressure will overload the motor,
slow the grinding action, put dangerous stress
on the grinding disc and causes breakage.
4. Move the product back and forth steadily.
16 GB / CY

Wire brushing

Q
WARNING!
Do not use brush that is damaged, or which
u
is out of balance. Use of damaged brush
could increase potential for injury from
contact with broken brush wires.
1. Avoid applying too much pressure which
causes over bending of wires, leading to
premature breakage.
2. Work with moderate feed, suited to the
material being worked.
3. Avoid bouncing and snagging the wire brush,
especially when working corners, sharp edges
etc. This can cause loss of control and kick-back.

After use

Q
12
1. Switch the product off, remove the battery
pack 4
2. Check, clean and store the product as
described below.

Cleaning and care

Q
WARNING!
Always switch the product off, remove
the battery pack and let the product
cool down before performing inspection,
maintenance and cleaning work!

Cleaning

Q
The product must always be kept clean, dry
o
and free from oil or grease. Remove debris
from it after each use and before storage.
Regular and proper cleaning will help ensure
o
safe use and prolong the life of the product.
Inspect the product before each use for worn
o
and damaged parts. Do not operate it if you
find broken and worn parts.
Never allow fluids to get into the product.
o
Clean the product with a dry cloth. Use a
o
brush for areas that are hard to reach.
In particular clean the air vents after every
o
use with a cloth and brush.
Remove stubborn dirt with high pressure air
o
(max. 3 bar).
NOTE
Do not use chemical, alkaline, abrasive or
u
other aggressive detergents or disinfectants
to clean this product as they might be harmful
to its surfaces.
and let it cool down.