The Dishwashing Results Are Not Satisfactory - hanseatic HGTI6082C14T7735ES Gebrauchsanleitung

Problem
The indicator (2) is
illuminated although
dishwasher salt has
been added.
The water is not
running or it is running
only very slowly.
The water is not
running off or only very
slowly.
The dishwasher is not
watertight.
The dishwasher can be
switched on/off, but not
cannot be operated.
The dishwasher cannot
be operated.

The dishwashing results are not satisfactory

Problem
There are residues or
streaks on the dishes.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the appliance
door is closed.
The buttons are locked.
Possible cause
The rinse aid is incorrectly
dosed.
The dishwasher salt is
depleted.
The dishwasher salt is
clumpy.
Troubleshooting table
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Arrange the inlet hose properly so
that it is not kinked (please see
"Checking and cleaning the filters"
on page EN-26).
Turn the water tap on completely.
Clean the filters (see "Checking
and cleaning the filters" on
page EN-26).
Lay out the outlet hose in a proper
manner (see page EN-30).
Have the door seal replaced (see
"Service" on page EN-42).
Have the defective hose replaced
(see "Service" on page EN-42).
Close the appliance door.
Unlock the buttons (see "Key lock"
on page EN-25).
Solution
Adjust the dispensed dose (see
"Adding rinse aid" on page EN-13).
Add dishwasher salt (see "Adding
dishwasher salt" on page EN-14).
Stir the dishwasher salt using the
end of a spoon or similar.
Page EN-39