The Dishwashing Results Are Not Satisfactory - hanseatic HG6085C14T7635EI Gebrauchsanleitung

Page EN-34 Troubleshooting table
Problem
The LED (2) is illu-
minated, although dish-
washer salt has been
added.
The water is not run-
ning or it is running
only very slowly.
The water is not run-
ning off or only very
slowly.
The dishwasher is not
watertight.
The dishwasher can
be switched on/off, but
cannot be operated.
The dishwasher cannot
be operated.

The dishwashing results are not satisfactory

Problem
There are residues or
streaks on the dishes.
Possible cause
The dishwasher salt is
clumpy.
There is a kink in the inlet
hose.
The water tap is not properly
on.
The filters are blocked.
The outlet hose is kinked,
has been extended or is
hanging too high up/too low.
The door seal is defective.
The outlet hose or the inlet
hose is defective.
The dishwasher can only be
operated when the appliance
door is closed.
The buttons are locked.
Possible cause
The rinse aid is incorrectly
dosed.
There is no dishwasher salt.
The dishwasher salt is
clumpy.
Solution
Stir the dishwasher salt using the
end of a spoon or similar.
Arrange the inlet hose properly so
that it is not kinked (see "Connect-
ing the inlet hose" on page EN-29).
Turn the water tap on completely.
Clean the filters (see "Check-
ing and cleaning the filters" on
page EN-26).
Lay out the outlet hose in the prop-
er manner (see page EN-29).
Have the door seal replaced (see
"Service" on page EN-36).
Have the defective hose replaced
(see "Service" on page EN-36).
Close the dishwasher door.
Unlock the buttons (see "Button
lock" on page EN-25).
Solution
Adjust the dispensed dose (see
"Adding dishwasher salt" on
page EN-14).
Add dishwasher salt (see "Adding
dishwasher salt" on page EN-14).
Stir the dishwasher salt using the
end of a spoon or similar.