Adjusting The Appliance Door's Accessibility - hanseatic HGTI6082C14T7735ES Gebrauchsanleitung

12. Lay the supplied drilling template on the
reverse side of the front panel in such a
way that the drilling template and the front
panel are flush at the top.
13. Transfer the drill holes from the drilling
template to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a drill bit (Ø 2 mm).
15. Remove the protective films from the
other hook-and-loop straps and stick the
straps to the front panel using the drilling
template.
16. Attach the front panel to the appliance
door of the dishwasher using the hook-
and-loop straps (40), hold the panel in
place, and carefully open the appliance
door.
(43)
17. Remove the 4 screws from the inside of
the appliance door. Screw the front panel
in place at these positions using the 4 en-
closed screws (43).
The front panel has been successfully
mounted.
Installation, connection and initial commissioning
(43)
Adjusting the appliance
door's accessibility
You can adjust how easy or difficult it is to
open the appliance door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force
of the appliance door by turning both lower
screws.
• So that the door is easier to access, turn
the screws in an anti-clockwise direction.
• To make the door more difficult to access,
turn the screws in a clockwise direction.
Page EN-35