hanseatic HGTI6082C14T7735ES Gebrauchsanleitung Seite 79

5. Remove the protective films from the side
end profiles (36).
6. Affix the end profiles to the left and right
front edges of the dishwasher. This will
prevent a crack being visible between the
dishwasher and the adjacent kitchen cup-
boards.
7. Push the dishwasher into the recess.
(31)
Installation, connection and initial commissioning
8. To position the dishwasher so that it is lev-
9. Check the alignment with a spirit level.
10. Make sure the top edge of the dishwasher
(36)
11. Screw the dishwasher to the kitchen unit.
el, the two front adjustable feet (31) and
the back foot on the appliance can be ad-
justed by up to 50 mm.
– The front adjustable feet are equipped
with slots. Insert a screwdriver into
one of the slots and turn the feet to
the height required.
– You can adjust the height of the rear
adjustable foot with the centre adjust-
ing screw. Use a Phillips-tip screwdriv-
er for this.
is level with the bottom edge of the work-
top to prevent it from tipping forward when
you open the appliance door.
(38)
(42)
– If you have granite worktops, remove
the internal side cover caps (37) and
screw the dishwasher to the adjacent
kitchen cupboards.
Replace the cover caps on the coun-
tersunk screws (42).
– For all other worktops, screw the
mounting bracket (38) firmly to the
worktop.
Page EN-33
(37)(41)