Mounting The Front Panel - hanseatic HGTI6082C14T7735ES Gebrauchsanleitung

Page EN-34 Installation, connection and initial commissioning

Mounting the front panel

A front panel must only be used for the model
with the article number 21172263.
You can mount a front panel on the appliance
door which matches your kitchen. The front
panel must not exceed 5 kg.
1. Hold the front panel against the appliance
door such that the lower side of the front
panel is flush with the adjoining kitchen
cupboards.
2. Measure the distance between the front
panel and the control panel.
(39)
3. A gap of 5 mm to 25 mm can be offset with
the 5 mouldings (39) included. Remove
the required number of moulding from the
block. To do so, move the moulding vigor-
ously but without using tools.
4. If you only need one trim strip, saw off the
four feet that stick out, clamp
the trim strip under the control
panel and secure it using both
countersunk screws (44).
Continue with Step 7.
5. If you need more than one moulding, turn
the lower moulding and push it onto the
other mouldings. This hides the feet and
makes the surfaces flat.
6. If you
– need two mouldings, secure these
using both countersunk screws (44).
– need three mouldings, secure these
using both countersunk screws (45).
– need four to five mouldings, secure
these using both countersunk screws
(46).
(40)
7. Pull the two pairs of hook-and-loop straps
(40) apart.
8. Remove the protective film from the same
type of hook-and-loop strap.
9. With the protective film removed, stick the
hook-and-loop straps onto the middle of
the recessed areas on the appliance door.
10. Cut the positions of the hook-and-loop
straps out of the drilling template.
11. Cut the number of mouldings used off the
drilling template.
(40)
(40)
(40)
(40)