Connecting The Mains Plug; Installation - hanseatic HGTI6082C14T7735ES Gebrauchsanleitung

Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous flow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
placed by a specialist (see "Service"
on page EN-42).
Do not use old or previously installed
■
inlet hoses.
3
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾-inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.

Connecting the mains plug

WARNING
Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
Prior to connecting the dishwasher,
■
ensure that you have page EN-4 tak-
en note of all the safety instructions
and adhered to them.
Installation, connection and initial commissioning
Fire hazard!
Improper handling of the appliance
can lead to fire.
■
•
•
•
•

Installation

Risk of damage to property!
Selecting the wrong screws can dam-
age the worktop.
■
•
•
1. Switch the fuse off.
2. Remove any cardboard, polystyrene and
Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
Please ensure you only connect the de-
vice to a professionally installed protec-
tive contact socket with sufficient fuse
protection (220-240 V~/50 Hz/10 A).
Ensure that the plug is installed in such a
way that the recess into which the dish-
washer will be fitted is deep enough even
when the plug is plugged in.
Do not use a multi-socket extension ca-
ble, multi-socket plug, travel adapter, ex-
tension cable or similar.
We recommend using a pulse-sensitive
residual current device (RCD).
Insert the mains plug into the socket.
NOTICE
Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
adhesive strips from the appliance's inte-
rior, if you have not already done so.
Page EN-31