Adjusting The Door's Accessibility - hanseatic HGTI6082C147735TS Gebrauchsanleitung

Page EN-34 Set-up, connection and initial start-up
10. Cut the positions of the velcro straps out
of the drilling template.
11. Cut the number of mouldings used off
the drilling template.
12. Lay the supplied drilling template on the
reverse side of the front panel in such
a way that the drilling template and the
front panel are flush at the top.
13. Transfer the drill holes from the drill tem-
plate to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
15. Remove the protective films from the
other velcro straps and stick the velcro
straps to the front panel using the drilling
template.
16. Attach the front panel to the door of the
dishwasher using the velcro straps (h),
hold the panel in place, and carefully
open the dishwasher door.
(k)
17. Remove the 4 screws from the inside
of the dishwasher door. Screw the front
panel in place at these positions using
the 4 enclosed countersunk screws (k).
The front panel has been successfully
mounted.
Adjusting the door's
accessibility
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
To adjust the door
– so that it is easier to access, turn the screws
in an anti-clockwise direction.
– so that it is more difficult to access, turn the
screws in a clockwise direction.
(k)