Adjusting The Door's Accessibility - hanseatic HGTI4582C10T7736ES Gebrauchsanleitung

12. Lay the enclosed drilling template on the
back of the front panel in such a way that
the drilling template and the front panel
are flush at the top.
13. Transfer the drill holes from the drilling
template to the front panel.
14. Drill the drill holes in the indicated posi-
tions using a (Ø 2 mm) drill bit.
15. Remove the protective films from
the other hook-and-loop straps and
stick the hook-and-loop straps to the
front panel using the drilling template.
Installation, connection and initial commissioning
16. Fix the front panel to the dishwasher door
(43)
(40)
17. Remove the 4 screws from the inside of
(40)
The front panel is now mounted.
Adjusting the door's
accessibility
You can adjust how easy or difficult it is to
open the dishwasher door. This setting is of-
ten required after the front panel has been
mounted. You can change the spring force of
the door by turning both lower screws.
•
•
using the hook-and-loop straps (40), hold
it firmly, and open the door carefully.
(43)
the door. Screw the front panel in place
at these positions using the 4 enclosed
screws (43).
To make the appliance door easier to
open, turn the screws anticlockwise.
To make the appliance door more difficult
to open, turn the screws clockwise.
Page EN-35