Check The Fuses In The Charging Station; Storage And Maintenance; Warranty; Support And Repairs - ZAPTEC Pro Kurzanleitung

English

Check the fuses in the charging station

1
Remove the front cover using the
SmartKey* special tool supplied with
the charging station, and take the
front cover off.
* If the charging station is mounted on a ZAPTEC Column, you must use a SmartKey Column
(supplied with the column) in order to access the charging station.

6 . Storage and Maintenance

The product must be stored in a dry place with a stable temperature.
The protective cover must always be fitted when the product is not in use.
The following periodic maintenance is recommended:
• Wipe down the charging station with a damp cloth.
• Make sure there are no foreign objects in the charging connector.
• Check that the charging station has no physical external damage.
In accordance with Norwegian law, annual periodic checks must be carried out
on all publicly accessible installations by qualified personnel. (Ref. NEK400)

7 . Warranty

We guarantee that the device is free from material faults and complies with
applicable consumer protection laws and regulations in the country in which the
product was purchased or the consumer resides. Further information about your
rights under consumer legislation can be found at zaptec.com/privacy.

8 . Support and Repairs

The installation technician/service partner is always the first line of support in
the event of problems with the installation. ZAPTEC strongly recommends that
the installation technician complete the dealer course for ZAPTEC Pro before
installing a ZAPTEC Pro system. In the event of any problems, see the chapter
on troubleshooting before contacting us via zaptec.com/support.
20
2
Check that the fuses in the fuse
window have not tripped (they
should all face upwards).
3
If any of the fuses have tripped,
remove the fuse cover using the snap
cover and flip the fuses up again. Fit
the fuse cover as in step two and clip
the cover into place.