ZAPTEC Pro Kurzanleitung Seite 13

I
7
G or H
Sealing cones
Place the sealing cone over the cable entry in order to
seal it properly. First seal the unused cable entry using the
sealing cone supplied.
The sealing cone must be pulled down towards the
junction box and then pushed all the way down, so that
the cone ends up in the correct position as shown below.
Visually check that the seal has a good sealing surface.
9
Test the installation
To test the installation after the cover has been screwed on,
you must use the female connection. If you test directly on
the back plate, the connections will be damaged.
3
10
Protect the connections
Apply the adhesive sticker to protect the connections.
Good sealing surface
Poor sealing surface
4
Hvis du installerer på 3-fas IT-nett, anbefaler vi at det benyttes 4 leder
kabel i tilfelle det installeres en transformator senere for bedre ladey-
telse. Da kan den nøytrale koblingen gjøres i sikringsskapet heller enn
på hver enkelt ladestasjon, slik at det blir enklere å gjøre fremtidige
oppgraderinger.
8
Screw on the junction box cover
Attach strain reliefs to both cables and the sealing cone
before placing the cover on the junction box and screwing
in the four screws.
Use the correct sealing cone for the cable. Check
7. For å teste installasjonen etter at lokket er skrudd på må du
the cable dimension and select an appropriate
bruke hunnkoblingen. Dersom du tester rett på bakplaten vil
koblingene bli ødelagt.
sealing cone. Small sealing cone – cable
dimension 10-16. Large sealing cone – cable
dimension 16-21.
23 0 V
Dept. Technical reference
Do not insert measuring pins, wires or anything
else into the quick-release connector on the
back plate. Voltage tests should be performed
directly on the coupling screws or using a
female coupling.
5
English
Created by
Fredrik Ostrem 07.1
Document type
Title
Bakplate ute innsta
6
13