Check The Circuit Breaker In The Charging Station; Storage And Maintenance; Guarantee; Support And Repairs - ZAPTEC Pro Installationsanleitung

Check the circuit breaker in the charging station

1
Remove the front cover using the
SmartKey* special tool supplied with
the charging station, and take the
front cover off.
* If the charging station is mounted on a Zaptec Column, you must use a SmartKey Column
(supplied with the column) in order to access the charging station.

6 . Storage and Maintenance

The product must be stored in a cool, dry place. The protective cover
must always be fitted when the product is not in use.
The following periodic maintenance is recommended:
• Wipe down the charging station with a damp cloth.
• Make sure there are no foreign objects in the charging connector.
• Check that the charging station has no physical external damage.
Periodic checks should be carried out on all publicly accessible installations,
in accordance with local legislation.

7 . Guarantee

We guarantee that the device is free from material faults and complies with
applicable consumer protection laws and regulations in the country in which the
product was purchased or the consumer resides. Further information about your
rights under consumer legislation can be found at zaptec.com/guarantee. Your
Zaptec product comes with a five (5) year guarantee. Please find the guarantee
document at zaptec.com/guarantee

8 . Support and Repairs

The installation technician/service partner is always the first line of support in the
event of problems with the installation. Zaptec strongly recommends that the
installation technician complete the dealer course for Zaptec Pro before installing
a Zaptec Pro system. If you are a Zaptec dealer, contact support as stated in your
dealership contract, or via zaptec.com.
2
Check that the circuit breakers in
the circuit breaker window have
not tripped (they should all face
upwards).
3
If any of the circuit breakers have
tripped, remove the circuit breaker
cover using the snap cover and flip
the circuit breakers up again. Fit the
circuit breaker cover as in step two
and clip the cover into place.
English
21