ZAPTEC Pro Kurzanleitung Seite 11

Location of the charging station/back plate
Avoid installing the charging
station in areas which are
exposed to direct sunlight.
High temperatures in the
device will reduce the
charging rate.
The back plate must be
mounted on a flat surface.
Installing and connecting the back plate
1
Mount the back plate
If the wall structure requires plugs/drilling, you must ensure
that dust and dirt do not get into the junction box.
It is important not to create any new holes in the back plate. The four existing holes must be used.
Creating new holes in the back plate will invalidate the warranty.
3
Find the cable
The recommended cable type is a round cable
(PFXP, Powerflex and PFSP), Ø 10–20 mm.
Fit the sealing cone onto the cable before you connect
the cables to the junction box.
90 -130 cm
x 4
2
Remove the cover on the junction box
Undo four screws and open the cover to access
the junction box.
G or H
4
Wiring
To limit the risk of leaks in outdoor installations, we recom-
mend connecting the cable to the bottom of the junction
box. If this is not possible, we recommend that the device
be thoroughly sealed and checked in accordance with the
manual, and that other seals be used (Sikaflex or similar).
Well-ventilated area.
Do not install the box close
to heat sources or in a closed
box.
Avoid positioning charging
stations close to objects that
may prevent the built-in 4G
LTE-M receiving a signal.
Min. 10 cm
English
11