ZAPTEC Pro Kurzanleitung Seite 16

English
The charging
station is placed
correctly on the
back plate.
5
Position the charging station on the back plate
Position the charging station on the back plate and check
that it makes full contact with the back plate. There should
be no gap between the charging station and the back plate.
Switch on the power supply to the installation
• Check that the status indicator illuminates green, which means
that the system is starting up and performing internal checks.
• Check that the status indicator changes from yellow to green
after 2–3 minutes.
• If the charging station illuminates purple, it is being updated.
See the chapter on troubleshooting for more information
if the status indicator illuminates a different colour.
Activate the charging station
• Download the ZAPTEC App from the App Store / Google Play.
Register as a user and log in.
• Stand close to the charging station you wish to configure.
• Enter your PIN code. This is unique to each charging station. This will be
stated on the box and the zipped bag, or alternatively can be obtained
from the ZAPTEC Portal cloud service (after the charging station has been
added to the installation in the ZAPTEC Portal)
• Go to settings and scan for charging stations. Check that you are
connected to the correct charging station. There should be a flashing white
light on the status indicator of the charging station.
• Configure the power grid in accordance with the installation, and select
the communication method to be used. If 4G LTE-M is used, the charging
station will automatically select the 4G setting as the default.
• The charging station is online when you can see a green bar on the screen.
• This must be done for all the devices in the installation.
Troubleshooting: If the charging station does not come online, check that the
network setup is in accordance with the network requirements in the chapter
"Internet and Network Requirements".
The portal installation must be set up identically to the electrical installation.
16
There is a gap
between the
charging station
and the back
plate. 6
Fit the front cover
Ensure that the cover for the status indicator (Z) is correctly
positioned before replacing the front cover again. In order
to replace the front cover, you must first position the cover
over the Type 2 port and then attach it to the charging
station.