Cleaning And Maintenance; Storing, Transport - Lux Tools A-HS-20/41T-2in1 Originalbetriebsanleitung

GB
Cutting hedges
NOTICE! Risk of damage to the
appliance! Take particular care close
to fences!
If trimmings, fence wire or similar is
caught in the cutting equipment,
switch the appliance off immediately.
– Remove blade guard.
– Do not push the point into the hedge.
– After switching off wait until the blade is
stationary.
– Mount blade guard.
Tips on hedge trimming
NOTICE! Risk of environmental
damage! Do not use the hedge trim-
mer during normal periods of quiet
and rest.
Before cutting a hedge, check that
there are no birds nesting.
1
2
1. Cut the hedge to the desired height.
2. Trim the side of the hedge diagonally from
bottom to top.
3. Round off the upper corners of the hedge.
4. Cut back the hedge somewhat at ground
level.

Cleaning and maintenance

DANGER! Risk of injury! Before any
maintenance or cleaning work:
• Remove the battery.
• Let the device cool down.
Overview of cleaning
If necessary
What?
Clean the machine ► Cleaning the device –
Oil cutting tool
60
3
4
How?
p. 60
Clean cutting tool with
brush. Then, spray oil on
all sides of the cutting
tool.
Annually
What?
Re-tension saw chain ► Re-tensioning the
Clean oil guide
groove of the saw rail.
Sharpen the saw
chain.
Cleaning
Cleaning the device
– Remove coarse dirt.
– Wipe down the device with a slightly
damp cloth.
Cleaning the oil guide groove of the saw
rail
– Remove the saw rail.
– Clean dirt from the oil guide groove of the
saw rail with a suitable tool. (plastic spat-
ula, do not use any steel tools!)
– Replace saw rail(► Assembling the saw
rail and saw chain – p. 57).
Re-tensioning the saw chain
► P. 5, item 6
– Lift the tip of the saw rail slightly.
– Tighten the tensioning screw for chain
tension (27) until the chain lies on the
underside of the saw rail.
Sharpening the saw chain
Special tools are required to sharpen the saw
chain; these guarantee that the cutting of the
chain occurs at the correct angle and the cor-
rect depth. We recommend that you have the
saw chain sharpened by a professional.

Storing, transport

Storing
DANGER! Danger of injury! Make
sure no unauthorised persons can
gain access to the appliance!
– Slip the protection cover over the cutting
equipment.
– Store the appliance where it is dry and
well ventilated.
Longer downtimes
If you are not going to be using the device for
a while, remove the chain oil from the device.
Store the device in a dry place.
Transport
– Slip the protection cover over the cutting
equipment.
How?
saw chain – p. 60
► Cleaning the oil
guide groove of the
saw rail – p. 60
► Sharpening the
saw chain – p. 60