Lux Tools A-HS-20/41T-2in1 Originalbetriebsanleitung Seite 58

GB
The battery pack must be charged prior to the
first start-up (charging time: ► Technical
data – p. 61).
► P. 5, item 8
– Press in the locking button (19) and
remove the battery from the device.
► P. 5, item 9
– Insert the battery pack into the charger.
– Plug the charger into the power supply.
The charging status is displayed by the con-
trol lights (20).
– Slot the battery pack into the device and
make sure it clicks into place correctly.
Checking the remaining capacity of the
battery
– Press the button (9).
The remaining capacity of the battery is dis-
played by the control lights (8).
Adjusting the length of the telescopic
rod
► P. 4, item 3
– Loosen the locking lever (3).
– Pull out telescopic rod (10) of desired
length.
– Tighten the locking lever (3) again.
Adjusting working position of the drive
unit
► P. 3, item 1
– Press unlock button (11) and bend drive
unit (2) until it clicks into place.
Check before use!
DANGER! Attention, danger of
injury! Do not operate the appliance
unless you did not find any faults. If a
part has become defective, make sure
to replace it before you use the appli-
ance again.
Check the safety devices and the safe condi-
tion of the appliance:
– Check all parts for tightness.
– Check the appliance for visual damage:
broken parts, cracks, etc.
Switching on/off
► P. 3, item 1
– Firmly hold product with hands and use
shoulder strap.
– Switching on: Push switch-on safety
lock (7) forward and simultaneously press
On/Off switch (8).
– Switching off: Release On-Off switch (8).
58
Operating as branch saw
Before use, familiarize yourself sufficiently
with the sawing technique for chain saws.
You will find information about this in the trade
literature. We recommend that you attend
suitable training sessions. The notes here
serve only as a complement!
Correct posture
DANGER! Risk of injury! Never
work on unstable subsurfaces!
Never work while standing on a lad-
der!
Do not work bent too far forward!
Only use the device under favourable
weather and site conditions!
– Stand with both legs securely on the
ground.
– Heed obstacles in the work area.
– While you are working, always hold the
device fast with both hands!
– The shoulder strap is be carried on left
shoulder!
– Hold the device:
• with the left hand on the saw pole
• with the right hand on the handle.
• balanced in a secure position.
Here's how to saw correctly!
DANGER! Risk of injury! Always
switch the motor off before you put the
device down!
• Search the work area and remove objects
which are in your way.
• When you begin work, check the safety of
the device (► Check before use! – p. 58).
• Take the device in both hands as
instructed.
Risk of kickback!
Kickbacks occur if the upper edge or tip of the
saw rail touch wood or other hard objects.
The device is thrown with high energy back
and forth, which can cause extremely severe
injuries.