Belt Tension Adjustment - Zipro Lite Bedienungsanleitung

EN
HOW TO PREPARE FOR USE
CAUTION! Follow the steps below during the assembly and use tools supplied with the
product.
Prepare sufficient space for the assembly operation.
Before you start using the treadmill,
raise the handrail arm upwards as high
as possible.
After you finish your workout, lower it.
PLEASE NOTE: Do not use the treadmill
with the lowered handrail.
PLEASE NOTE: Before you use the
treadmill, read the manual carefully.

BELT TENSION ADJUSTMENT

WHEN SHOULD I INCREASE BELT TENSION?
As a result of regular use, the running belt may require tensioning.
 A too loose belt may stop despite a running motor.

Do not overtension the belt as it may damage the motor, shaft, or bearings.
 A correctly stretched belt can be lifted on the sides up to about 5–7.5 cm. It is easily
verifiable. The belt is tensioned correctly if you can fit three fingers under it.
The belt needs to be tensioned when it starts to slip, slide sideways, or curl during training.
Place the treadmill on a flat surface. Run the treadmill at about 6–8 km/h and note the deviation of
the running belt.
INCREASING BELT TENSION
A special wrench was included in the delivery. Place it in the left belt adjustment bolt in the rear of
the treadmill. Rotate the wrench 90 degrees clockwise (Fig. C). This way, you stretch the rear roller
and increase belt tension. Repeat for the right bolt. Make sure the bolts are tightened equally.
Repeat on both sides until the belt tension is correct.
REDUCING BELT TENSION
Belt tension is reduced in a similar way to how it is increased. Rotate the wrench counterclockwise.
21