Herunterladen Inhalt Inhalt Diese Seite drucken

Folding And Unfolding; Belt Tension Adjustment - Zipro Notus Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 42
EN

FOLDING AND UNFOLDING

CAUTION! Before folding the product, make sure all bolts are tight.
Folding the device
Lift the running belt of the device to the
horizontal position until the lock clicks.

BELT TENSION ADJUSTMENT

WHEN SHOULD I INCREASE BELT TENSION?
As a result of regular use, the running belt may require tensioning.
A too loose belt may stop despite a running motor.
Do not overtension the belt as it may damage the motor, shaft, or bearings.
A correctly stretched belt can be lifted on the sides up to about 5–7.5 cm. It is easily
verifiable. The belt is tensioned correctly if you can fit three fingers under it.
The belt needs to be tensioned when it starts to slip, slide sideways, or curl during training.
Place the treadmill on a flat surface. Run the treadmill at about 6–8 km/h and note the deviation of
the running belt.
INCREASING BELT TENSION
A special wrench was included in the delivery. Place it in the left belt adjustment bolt in the rear of
the treadmill. Rotate the wrench 90 degrees clockwise. This way, you stretch the rear roller and
increase belt tension. Repeat for the right bolt. Make sure the bolts are tightened equally.
Repeat on both sides until the belt tension is correct.
29
Unfolding the device
Hold the running belt and release the folding
lock (indicated with the arrow). Lower the belt
to the railing level.
The belt will now descend automatically.
PLEASE NOTE! Ensure there are no third
party or animals in the immediate treadmill
vicinity when its belt is lowered.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis