Zipro Lite Bedienungsanleitung Seite 26

TROUBLESHOOTING
CAUTION! Opening the housing of the device without a prior contact with a manufacturer's
service voids the warranty. If you suspect a failure that requires the housing to be opened,
contact manufacturer's service.
Error description
----- Safety key issue
E01 The computer does not
work
E02 The motor does not
operate
E03 The computer failed to
detect speed sensor signal
for 15 seconds
E04 Communication error
E05 Overload error
E06 Explosion-Proof Protection.
Incorrect power supply
E07 Nothing is displayed
Possible causes
The safety key is not connected.
The computer is damaged.
The computer is incorrectly
connected.
The signal cable is broken or
insulation is worn
The computer is damaged
The connection between the control
board and the computer is blocked
Incorrect supply voltage
Incorrect connection of the motor
cable
The controller is damaged
Sensor connection incorrect
Sensor plug connection incorrect
Sensor failure
Incorrect connection or damage to
the wires.
Motor failure
Too low rated current in the
controller.
Current exceeds the rated value
Supply voltage too low
Short circuit
The safety key is out
Solution
Connect the safety key correctly.
Contact manufacturer's service.
Verify the connection of computer cables.
Verify plug connections. If it is correct and
the problem persists, contact the customer
service of the manufacturer's service.
Contact the manufacturer's service.
Contact the manufacturer's service.
Make sure the voltage is correct. If the
problem persists, contact the customer
service of the manufacturer's service.
Disconnect the cable and connect it again. If
the problem persists, contact manufacturer's
service.
Contact the manufacturer's service.
Contact the manufacturer's service.
Verify plug connections. If it is correct and
the problem persists, contact manufacturer's
service.
Contact manufacturer's service.
Contact manufacturer's service.
Make sure the motor has not burnt out. If
not, disconnect the treadmill from the mains
and reconnect it. If the problem persists,
contact manufacturer's service.
Replace the controller. Contact the
manufacturer's service.
Make sure the weight of the user does not
exceed the maximum value for the device.
Connect the device to the correct voltage.
Contact manufacturer's service.
Insert the safety key.
EN
26