Herunterladen Inhalt Inhalt Diese Seite drucken

Belt Tension Adjustment - Zipro Tekno Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 41
EN
ADJUSTING RUNNING BELT INCLINATION
The inclination of the running belt of the treadmill can be adjusted. You can set one of the three
inclinations by changing the position of the inclination adjustment lock as shown in the picture.
The maximum inclination of the
running belt.

BELT TENSION ADJUSTMENT

WHEN SHOULD I INCREASE BELT TENSION?
As a result of regular use, the running belt may require tensioning.
A too loose belt may stop despite a running motor.
Do not overtension the belt as it may damage the motor, shaft, or bearings.
A correctly stretched belt can be lifted on the sides up to about 5–7.5 cm. It is easily
verifiable. The belt is tensioned correctly if you can fit three fingers under it.
The belt needs to be tensioned when it starts to slip, slide sideways, or curl during training.
Place the treadmill on a flat surface. Run the treadmill at about 6–8 km/h and note the deviation of
the running belt.
INCREASING BELT TENSION
A special wrench was included in the delivery. Place it in the left belt adjustment bolt in the rear of
the treadmill. Rotate the wrench 90 degrees clockwise. This way, you stretch the rear roller and
increase belt tension. Repeat for the right bolt. Make sure the bolts are tightened equally.
Repeat on both sides until the belt tension is correct.
REDUCING BELT TENSION
Belt tension is reduced in a similar way to how it is increased. Rotate the wrench counterclockwise.
29
Running belt slightly inclined.
Running belt flat.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis