Belt Tension Adjustment - Zipro Olympic Bedienungsanleitung

EN
TREADMILL FOLDING/UNFOLDING INSTRUCTIONS
PLEASE NOTE! Before you start folding, check if all the bolts are tight and disconnect the power
supply cable.
Device folding
Raise the running belt (A) of the device upright
until you hear the sound of the folding
mechanism lock (B).

BELT TENSION ADJUSTMENT

WHEN SHOULD I INCREASE BELT TENSION?
As a result of regular use, the running belt may require tensioning.
 A too loose belt may stop despite a running motor.

Do not overtension the belt as it may damage the motor, shaft, or bearings.
 A correctly stretched belt can be lifted on the sides up to about 5–7.5 cm. It is easily
verifiable. The belt is tensioned correctly if you can fit three fingers under it.
The belt needs to be tensioned when it starts to slip, slide sideways, or curl during training.
Place the treadmill on a flat surface. Run the treadmill at about 6–8 km/h and note the deviation of
the running belt.
INCREASING BELT TENSION
A special wrench was included in the delivery. Place it in the left belt adjustment bolt in the rear of
the treadmill. Rotate the wrench 90 degrees clockwise (Fig. C). This way, you stretch the rear roller
and increase belt tension. Repeat for the right bolt. Make sure the bolts are tightened equally.
Repeat on both sides until the belt tension is correct.
REDUCING BELT TENSION
Belt tension is reduced in a similar way to how it is increased. Rotate the wrench counterclockwise.
29
Device unfolding
Holding the running belt (A), release the
folding mechanism lock (as shown by the
arrow) (B). Holding the running belt, lower it
slowly to the floor.
PLEASE NOTE! Ensure there are no third
party or animals in the immediate treadmill
vicinity when its belt is lowered.