Zipro Lite Bedienungsanleitung Seite 22

CENTRING THE RUNNING BELT
WHEN SHOULD I CENTRE THE BELT?
The belt may move to one side as a result of different
running styles (most often greater load
on one leg). This is why the belt may need to be adjusted
from time to time.
The belt should centre itself as the treadmill is used. It
has to be adjusted when it diverges
to the right or left.
CENTRING THE BELT
Run the treadmill at a low speed (eg. 3 km/h). Check
which side the belt moves to.
 If the belt moves to the right, place the wrench in
the right adjustment bolt.
Rotate the wrench 90 degrees clockwise (Fig. A).
Note whether the belt is centred.
If it continues to diverge to the right,
rotate the wrench 90 degrees again.
 If the belt moves to the left, act similarly
on the left adjustment bolt (Fig. B).
MAINTENANCE
In order to ensure the maximum safety of treadmill operation, it is advisable to check the wear of
its parts regularly. In concerns in particular tightness and condition of nuts, bolts, moving parts,
bushings, etc.
Store the device in a dry and warm place. Do not expose the device to direct sunlight.
CAUTION! Always turn the treadmill off and disconnect the power cord before maintenance.
CLEANING
Regular cleaning will extend the lifetime of the device and ensure high performance.
Clean the treadmill with a soft and moist cloth. This does not apply to electrical elements, the
motor, or internal parts; do not let water reach these areas. Protect the surface of the running belt
(and the surface below it) against water.
CLEANING THE MOTOR
Remove dust from the motor at least once a year. To this end, disconnect the power cord of the
treadmill, wait about an hour, and remove the motor cover. Use compressed air or brush to
carefully remove the dust. Reinstall the motor cover and connect the device to the mains. The
treadmill is ready for use.
EN
22