Inhaltsverzeichnis
Werbung
1
STEERING
4. Install:
• Ring nut 1
Tighten the ring nut using the ring nut
wrench 2.
Refer to "STEERING HEAD INSPEC-
TION AND ADJUSTMENT" section in the
CHAPTER 3.
5. Check the steering shaft by turning it lock
to lock. If there is any binding, remove the
steering shaft assembly and inspect the
steering bearings.
6. Install:
• Plain washer 1
7. Install:
• Front fork 1
• Handle crown 2
• Main switch 3
• Hose guide bracket 4
NOTE:
• Temporarily tighten the pinch bolts (under
bracket).
• Do not tighten the pinch bolts (handle crown)
yet.
8. Install:
• Guide (speed sensor lead) 1
NOTE:
After installing the guide as shown, pass the
speed sensor lead through the guide.
5 - 50
CHAS
7 Nm (0.7 m · kg, 5.1 ft · lb)
Werbung
Inhaltsverzeichnis
