Inhaltsverzeichnis
Werbung
1 Hot starter cable
2 Clutch cable
3 Throttle cable (return)
4 Throttle cable (pull)
5 Ignition coil
6 Negative battery lead
7 Starter motor lead
8 Coolant reservoir tank breather
hose
9 Cable holder
0 Coolant reservoir hose
A Clamp
B CDI unit lead
C CDI unit
D CDI unit band
E CDI unit stay (frame)
F Cable bracket
Ì
Ë
8
7
6
CABLE ROUTING DIAGRAM
È Pass the throttle cables, clutch
cable and hot starter cable
through the cable guides.
É Pass the throttle cables, clutch
cable and hot starter cable
between the radiator and frame,
then over the middle radiator
mounting boss.
Ê Pass the throttle cables and
clutch cable on the outside of
the ignition coil.
Ë Pass the carburetor breather
hose
(throttle
cable
through the hose holder.
Ì Fasten the coolant reservoir
tank breather hose and carbure-
tor breather hoses together with
a plastic locking tie.
C
D
F
A Ð
Ï E
B
0
Í 9
B
2 - 25
Í Fasten the grommet of the clutch
cable with the cable holder.
Î Fasten the CDI unit lead to the
frame with a plastic locking tie
ends at the lower of the frame
and cut off the tie end.
Ï Insert the CDI unit band over the
CDI unit stay (frame) as far as
possible.
Ð Fasten the starter motor lead
and negative battery lead to the
cable bracket in its slot with a
cover)
plastic locking tie and cut off the
tie end.
D
C
B
Î A
A
Ê
5
SPEC
1
A
2
3
4
È
É
Werbung
Inhaltsverzeichnis
