Inhaltsverzeichnis
Werbung
Zero mm
Zero mm
(Zero in)
(Zero in)
HANDLEBAR
10. Install:
• Start switch 1
• Master cylinder 2
• Master cylinder bracket 3
• Bolt (master cylinder bracket) 4
• Clamp 5
NOTE:
• The start switch and master cylinder bracket
should be installed according to the dimen-
sions shown.
• Install the bracket so that the arrow mark a
faces upward.
• First tighten the bolt on the upper side of the
master cylinder bracket, and then tighten the
bolt on the lower side.
11. Install:
• "ENGINE STOP" button 1
• Clutch lever holder 2
• Bolt (clutch lever holder) 3
• Hot starter lever holder 4
• Bolt (hot starter lever holder) 5
• Clamp 6
NOTE:
• The "ENGINE STOP" button, clutch lever
holder and clamp should be installed accord-
ing to the dimensions shown.
• Pass the "ENGINE STOP" button lead in the
middle of the clutch lever holder.
12. Install:
• Clutch cable 1
• Hot starter cable 2
NOTE:
Apply the lithium soap base grease on the
clutch cable end and hot starter cable end.
5 - 44
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
4 Nm (0.4 m · kg, 2.9 ft · lb)
Werbung
Inhaltsverzeichnis
